Equipment and tools required for installation:
1. Reliable lifting equipment (such as a small crane)
2. Apply wrench, hammer, screwdriver, electric tools and megohmmeter, such as clamp current meter.
3. Cable tie line.
Electric pump device:
1. The reverse check valve body of the electric pump is connected with a short water delivery pipe, and the clamping device clamping plate is clamped in the proper orientation of the pipe. Will pump lift gradually into wells, ratio and clamping reliably into Jingtai, loosen hook, the second section tube reliably received first pipe section, fastening screw and remove the first pay plywood, according to the above methods, the pump continues to fall, all piping lifting pipe) installed. Finally, in the appropriate range of the pipe clip plate, firmly fixed on the platform, connected to water pipe (head).
2. Electric pump should be submerged under the dynamic water level, the bottom is not less than 3m from the bottom of the bottom, but not more than 70m. depth of the motor can not be more than the part of the device to touch the sediment. Otherwise, the motor for cooling is not good, will overheat burning.
3. Cable in the downhole device should not be distorted and excessive tension and application of wire the cable with each water pipe (Yang water) on the upper and lower ends of the banding together.
