Shenlong Pump News Center

pump industrys new and pump technology articles

we provide advice of submersible pump installation,submersible pump working,submersible pump troubleshooting,submersible pump stopped and other pump technology articles.

Technology

Home > News > Technology

Four methods to solve the faults of motor of self priming pump

Self-priming sewage pump

 

1. After the power is connected to the pump is still not working

It may be because the power plug or line can not drive up, short circuit and other reasons.

2. Bad start or start when there is noise

Maintenance available small bamboo sheet shifting wind leaf, if the motor can be normal operation, that is the starting winding is damaged should be replaced the same capacity capacitor or repair the startup winding; if the motor is stuck, is due to the fault of motor and pump head, such as the damage of bearing, impeller stuck.

3. The motor to run, but the speed is slow, the housing overheating, burning

There may be caused by a short circuit of the motor, the motor should be dismantled to see the seriousness of the damage repair.

4. The operation of noise and vibration

Most of the bearing damage or bearing chassis and the mismatch, need to dismantle the motor to check, if the bearing is damaged should be replaced; if the bearings "running round", the pump shell with surface using chisel flowers; if the bearings "running in the round", the motor shaft wear parts of the chisel flowers processing, serious wear and tear, the first turning method for repair welding.

Chat Online & Leave Message

Please send email to : enquiry@apkpump.com
Or leave message in following form.
@
Please briefly tell us your needs (pump type, working envirment)