Mine Submersible Pump 460QK40-408

30 years professional submersible pump manufacturer in China

Now looking for global Mine Submersible Pump distributor,with high quality pump,intimate service and big market prospects.

Mine Submersible Pump

Home > Products > Submersible pump > Mine Submersible Pump

Mine Submersible Pump 460QK40-408

Flow:40 m³/h
Lift:408 m
Caliber:460 mm
Power:100 KW
Temperature:°C
Quality warrantyOne year warranty and lifetime maintance
 
Skype : dragonpumps dragonpumps
E-Mail : enquiry@apkpump.com
Whatsapp/Wechat : 0086-17537187726
Online consultation    Leave Message

   Due to the new bearing structure and materials, it can bear large axial force and ensure the service life of submersible motor. When the motor power is greater than 600kW, a small impeller is set at the lower end of the rotor to make the cooling water in the motor circulate automatically and improve the cooling effect. When the motor power is less than 600kW, the rotor is equipped with spiral water tank, which can also ensure the cooling effect.

Mine submersible pump features:

1. High safety and reliability: the pump and supporting submersible motor are designed and used on the premise of diving into the water.

2. High efficiency, energy saving and high degree of automation: the surface is powered separately, and multi-functional detection and control can be realized on the ground. The electric pump is equipped with multiple monitoring and protection, which is easy to implement intelligent monitoring, remote control and network management.

3. The water pump unit can be used vertically, obliquely and horizontally

4. Easy installation and operation

Mine submersible pump working conditions:

1. Water temperature not higher than 25℃

2. The content of solid matter in water shall not be greater than 0.5% 0 (Note: the content of solid matter in water shall be indicated in the contract so that the manufacturer can choose the shaft extension sealing method.)

3. The water velocity on the surface of the motor shall not be less than 0.5m/so. The motor shell is provided with an anti seawater coating. Pay attention not to scratch the coating when going into the seawater. The motor can work in the seawater for up to 3 months at a time. After the work expires, the motor must be lifted out of the seawater, and the coating must be carefully checked for falling off and damage. If any, the coating shall be brushed after being cleaned and decontaminated with clean water, The corrosion of the zinc plate at the motor base shall be checked, and it shall be replaced in time before it is put into the sea.

(1). Coating material: type B epoxy coal asphalt primer (the first coat)

(2). Type B epoxy coal tar pitch enamel (2nd coat)

4. The pump suction port is 2 meters below the water surface.

5. The rotation direction of the pump is clockwise when viewed from the coupling end to the pump.

mine-submersible-pump.jpg

Notes for mining submersible pump:

1. The motor must be filled with water.

2. The instructions must be read before installation and use.

3. Ensure the flow rate of water on the surface of the motor. If it cannot be guaranteed, install a deflector (cooling water cover).

4. The electric pump must be reliably grounded for non well applications.

5. The electric pump must fully submerge into the water, and the minimum water level shall be 2m higher than the pump inlet during operation.

6. If it is necessary to test run the submersible pump on the ground, the pump cavity must be filled with water or other lubricating fluid. Otherwise, the sliding bearing will be damaged.

Chat Online & Leave Message

Please send email to : enquiry@apkpump.com
Or leave message in following form.
@
Please briefly tell us your needs (pump type, working envirment)